- BACKUP EXEC 2010 LINUX SERIAL NUMBERS
- BACKUP EXEC 2010 LINUX INSTALL
- BACKUP EXEC 2010 LINUX SERIES
- BACKUP EXEC 2010 LINUX DOWNLOAD
- BACKUP EXEC 2010 LINUX WINDOWS
(Figure 20)īy default the VRTSralus.init service is stopped, Follow steps mentioned below Fig 21 to start the service.
BACKUP EXEC 2010 LINUX WINDOWS
Its recommended to add the Windows host entry in the /etc/hosts file on the Linux server. Note: A host name can be used, however make sure that the Linux server can resolve the host name properly. The installation utility will ask for the Media Server IP address or Hostname to display the remote agent as a selection in the media server's backup selection tree as shown in Figure 10 below.
BACKUP EXEC 2010 LINUX SERIES
The installation utility will now ask a series of questions to configure RALUS (Figure 9).To configure RALUS with user friendly configuration press "Y" (Figure 8).Installation requirement checks completed successfully as shown in Figure 7 below.
BACKUP EXEC 2010 LINUX INSTALL
RALUS will check and install the following rpms on Linux server as shown in Figure 6 below:.RALUS performs the initial system check as shown in Figure 5 below:.Type the LINUX server IP address or Hostname and press Enter as shown in Figure above. The installation screen appears: (Figure 4).At the command prompt, type: installralus and press in the directory that the install script is present shown in Figure 3 below:.Navigate to the Linux folder that was extracted in Step 3 as shown in Figure 2 below:.Note: This is a two step command to extract and untar the file. Or, in two commands as shown in Figure 1b below: Note: If the file does not have ".gz" extension that means its already uncompressed and one has to just extract it using "tar xvf" command. V = Verbose - display contents as it is tarring or extracting Z = Gunzip(uncompress) it before extracting, used on file ending in. Note: This is a one step command to extract and untar the file. gz file to the Linux/Unix host and extract the files there as shown below. Doing so will cause difficult to diagnose installation errors. Note: Do not extract the RALUS installer files on a Windows system and copy the resulting files to the Linux/Unix host.
BACKUP EXEC 2010 LINUX DOWNLOAD
On a LINUX host, download the installation files from the Symantec support site.Ĭonnect to the target host using a terminal session or Log On locally with super user, root, or administrator privileges.Įxtract the contents of the installation files that were downloaded in Step 1 using the following command Figure 1a below: To install the Remote Agent for Linux and UNIX Servers on the LINUX host: It is also advisable to check the RALUS compatibility with LINUX host before installation, To check the compatibility refer to:
BACKUP EXEC 2010 LINUX SERIAL NUMBERS
Note: RALUS is an additionally purchased option and is enabled by installing the RALUS serial numbers on the Backup Exec media server.įor Backup Exec 2010, there is no separate download available, RALUS is included on the DVD, and can be found in the "LinuxUnixMac" folder present at the root of the DVD for Backup Exec for 2010. Step by step installation of the Backup Exec Remote Agent for Linux and UNIX Servers (RALUS) on the Red Hat Linux platform.įollow these steps to install the Remote Agent for Linux and UNIX Servers on Red Hat Linux: